Kenmore 625.38156 owner manual Remote Location

	Outside	Faucet
	(!tard	Water)	Outside	Faucet	BLUE Tubing
			(Hard	Water)	to Reverse
					Osmosis Air
Soft, Cold		Water			Gap Faucet
Soft,	Hot Water
				GREEN
			Sediment	Tubing to
				Reverse
			Filter
Remote Location				Osmosis
				System
Installation					Reverse Osmosis
					System
					I
					YELLOWTubing
					to -lankStorage
					I
					Storage
					_12mk
		Water	Heater	Water Meter
1!4"	RED Tubing			Valve

c_	Sump		Airgap
			1-1/2"
Airgap
1q/2"
		Laundry Tub	Floor
Standpipe	Airgap		Drain

INSTALL A REMOTE DRAIN POINT AND AIR GAP (Remote Location)

You can also run the drain tubing to an existing drain in the house. A floor drain, laundry tub, standpipe, sump, etc. are suitable drain points. See Figure 10. This type of drain is the preferred over the p- trap drain adapter. Check your local codes. Longer lengths of tubing (see parts list in back of manual) may be needed.

Always be sure to provide an air gap between the end of the hose and the drain point. This will prevent water from backing up into the system. Airgaps are required code in most areas.

Figure 9

Figure 10

To install a remote drain point, complete the following steps:

1.Locate the 1/4" red tubing on the Reverse Osmosis fil- ter assembly. See Figure 9.

2.Determine if this length is long enough to reach the drain point.

3.if not, disconnect the 1/4" red tubing and replace with an adequate length of tubing to reach the drain point. Refer to Step 6 later in the manual on how to discon- nect and connect tubing.

NOTE: A flow control insert is located in the red tube, Refer to Key No. 10 on Page 26. This insert must be saved and placed in the new length of tub=

4.Run the tubing to the drain point and secure at the end with a bracket (purchased locally). See Figure 10. Provide a 1-1/2" air gap between the end of the tube and the drain. See Figure 10.

Questions? Call The Kenmore Water Line 1-800-426-9345or visit KenmoreWater.com

10