Installation Steps, Cold Water Supply Fitting

			INSTALLATION			STEPS
			STEP 1 - COLD WATER SUPPLY FITTING
Check	and	comply	with local plumbing codes	as	you plan,	then install a cold feed (supply) water	fitting.	The
fitting	must	provide	a leak- tight connection to	the	water filter 3 / 8" tubing. A typical connection		using the	in-

cluded water supply fitting is shown in FIG.2 - A. An optional connection using standard plumbing fittings

(not included), is shown in B.

A. WATER SUPPLY FITTING

1, Close the house main water shutoff valve and open faucets to drain water from the sink cold water pipe.

2.Remove nut that connects the cold water faucet to cold water plumbing.

3.Thread water supply fitting onto pipe and reconnect nut to bottom of fitting.

(compression type shown)

Note: Be sure to turn off the water supply and open a low faucet to drain the pipe.

Complying with plumbing codes, install a fitting on the cold water pipe to adapt 3/8" OD tubing. A typi-

cal connection is shown in figure 2B. If threaded fit-

tings are used, be sure to use pipe joint compound or Teflon tape on outside threads,

FIG. 2

A.WATER SUPPLY CONNECTION (using Included water supply fitting)

water supply fitting

Water Filter inlet

3/8" tubing to

_lpeer cold _

B.WATER SUPPLY TYPICAL CONNECTION (using compression fitting)

-parts not Included -

cold water shutoff