Kenmore 625.3847 owner manual Assemble Faucet, 8blue, RO System

- STEP 3: INSTALL FAUCET (cont.)-

B. ASSEMBLE FAUCET

1.If not already assembled, install the rubber washer,

spacer, flat (or lock) washer and hex nut onto the

threaded faucet stud.

2.Apply Teflon tape to the end of the faucet stud.

Turn the tubing adapter with a blue collet onto the stud and hand tighten, then wrench 1/4 turn only.

BE CAREFUL NOT TO CROSS THREAD.

3.Wet the o-ring seals on the faucet spout. Then, re- move and discard the short piece of tubing from the faucet body and insert the spout in its place.

4.CONNECT TUBING TO FAUCET AS FOLLOWS.

a. Take the separate length of 3 / 8" black tubing put

an end through the larger hole in the rubber wash- er. Slide the end onto the larger barb fitting on the bottom of the faucet.

Note: To soften end of tubing, hold under hot water.

b. Route 1/4" red tubing from RO up through the sink hole and slide end onto the smaller barb fitting

(heat end if needed) on the faucet.

c. Route 3/8" blue tubing from RO up through the sink hole and push end all the way into the tubing

adapter fitting on the bottom of the faucet. Pull on the tubing to be sure it's held firmly in the adapter fitting. See pages 12 and 13 for tubing connection instructions.

5.Lower the faucet into the sink or countertop hole.

6.On the underside of the sink or countertop, insert

the large steel washer between the mounting hole and the spacer on the faucet stud (see assembled view). Then, turn the hex nut up to the spacer and

tighten. Tighten the hex nut so the faucet cannot

move, but do not overtighten and break the faucet.

-STEP 4: INSTALL RO ASSEMBLY -

Hang the assembly on the included hanger washers, or lay on the cabinet floor, as desired.

1. Refer to FIG. 7 for wall mounting. Hold the assem-

bly up to the wall surface and mark locations for the

hanger washers. Indicator marks on top of the brack- et are the needed 10-1/2" apart.

2.Install hanger washers at least 15-1/2"up from the

cabinet floor, allowing room to remove sumps from

filter heads. Wood screws are provided, or obtain

other fasteners as needed.

FIG. 6 ]

insert spou_

remove tub-

ing piece

ASSEMBLED IN

MOUNTING HOLE

rubber
washer	_	=_,=_/spacer
		°ek
	_.,_	hex nut
	_._	tubing adapter
	putty	blue collet

steelwasher		.J I	_	holein sink or
	_	_1-[		countertop
				114" red tubing
to drain	point _-_-//	\	\/	/_
	YJ
	3/8"blue /	TUBING		FROM
	tubing	RO SYSTEM
FIG. 7 ]	hanger	I'_,_
	washer (2)	I_
screw	(2) _(_)		10-1/2"

15-1/2" min.

up from floor

7