Care & Cleaning
General cleaning
Refer to the Cleaning recommendation table in the Care &
Cleaning section for more detailed information about
cleaning specific parts of the range.
Before manually cleaning any part of the range, be sure all controls are turned OFF and the range is COOL. The range may be hot and can cause burns.
Ammonia must be rinsed before operating the oven. Provide adequate ventilation.
Aluminum foil and utensils
NEVER cover any slots, holes or passages in the oven bottom or cover an entire oven rack with materials
such as aluminum foil. Doing so blocks air flow through the
oven and may cause CARBON MONOXIDE poisoning.
Aluminum foil linings may trap heat, causing a fire hazard.
Aluminum foil - Use of aluminum foil on a hot cooktop can damage the cooktop. Do not use thin aluminum cooking utensils or allow aluminum foil to touch the surface burners under ANY circumstances.
Aluminum utensils - The melting point of aluminum is much lower than that of other metals. Care must be taken when aluminum pots or pans are used on the cooktop. If aluminum pans are allowed to boil dry when using the cooktop, the utensil may be damaged or destroyed.
Replacing oven light (some models)
Be sure the range is unplugged and all parts are COOL before replacing oven light. Wear a leather- faced glove for protection against possible broken glass.
The oven light is located at the rear of the oven cavity and is covered with a glass shield held by a wire holder. The glass shield protects the light bulb and must be in place whenever the oven is in use.
glass shield
wire
holder
iiiiiiiiiiiiiiii>¸¸4¸¸
............
To replace the interior oven light bulb:
1.Turn electrical power off at the main source or unplug the range.
2.Press wire holder to one side to release the glass shield that covers the light bulb.
3.Replace light with a new 40 watt appliance bulb.
4.Replace glass shield over bulb and snap wire holder back into place.
5.Turn power on at the main source (or plug the appliance in).
6.The clock will then need to be reset. To reset, see Setting clock in this Use & Care Guide.
21
