Kenmore 9000416647(8811) manual Rinse aid, Setting amount of rinse-aid

aus

Rinse aid

As soon as the rinse-aid refill indicator

4lights up on the control panel, refill with rinse aid.

The rinse aid is required for stain-free utensils and clear glasses.

Use only rinse aid for domestic dish- washers.

Combined detergents with rinse-aid com- ponent may be used up to a water hard- ness of 21 _dH (37 _fH, 26 _Clarke,

3,7 mmol/l) only. If the water hardness is over 21 _dH, rinse-aid must be used.

Open the dispenser 28 by pressing and lifting the plate on the cover.

Carefully pour rinse aid up to the max. mark in the filler opening.

Close cover until it clicks shut.

To prevent excessive foam formation during the next rinse cycle, remove any rinse aid which has run over with a cloth.

Setting amount of rinse-aid

The amount of rinse-aid dispensed can be

set from		to	. The factory setting
is	.

Do not change the amount of rinse-aid unless streaks (select lower setting) or water stains (select higher setting) are left on the utensils.

Open the door.
Switch on ON/OFF switch					.
			1
Hold down programme button
					A
and press START button					until on
			7
the digital display is indicated					.
Release both buttons.
Press programme button					until the
			A
factory set value		is indicated on
the digital display		.
	8
To change the setting,
press programme button				.
			C

Each time the button is pressed, the set value increases by one level; when the

value of	has been reached, the
display jumps back to			(off).
Press START button			.
		7

The set value is saved.

Close the door.

Switching off rinse-aid refill indicator

If the rinse-aid refill indicator 4 is

impaired (e.g. when using combined detergents containing rinse-aid component), it can be switched off.

Proceed as described under “Setting amount of rinse-aid” and set the value

to .

The rinse-aid refill indicator 4 is now switched off.

6