Hinge Location Of A Reversible Door

Door

Door StOpper

HINGE LOCATION OF

A REVERSIBLE DOOR

Refer to the disassembly diagram and change the door hinges in the following procedure.

1.	Tilt the refrigerator	back or lay it on its back.	.	The direction in which the door opens has
				now been changed; however, the following
	Use a pad or blanket to protect the floor and
				points should be checked:
	to avoid scratching the painted finish.
				a.	Make sure the door is on straight.
2.	Remove the leveling legs by turning them

	counterclockwise. Remove the lower			b.	Make	sure that there is no space
	hexagonal head screws, two on the hinge				between the door gasket and the
	side and one near the front corner of the				refrigerator unit itself when the door is
	other side.				closed.
3.	Pull the door away from the top table			C.	Make	sure that the gasket on the hinge
	assembly and set the door aside.
					side is not caught between the door
4.	With a Philips plus screw driver, unscrew the
					and the unit when the door is opened
	shaft hinge top and transfer to tile opposite
					or closed. (If the door is forced closed
	side.
					when the gasket is caught, the gasket
5.	Insert the door back to the shaft hinge top
					may be damaged.)
	which was screwed unto the opposite side.

6.	Remove the refrigerator door hinge stopper			When checking the above points, if it is
	and the hinge stopper screws and install
				discovered		that the door is not installed
	them on the other side of the door.			properly (this is apt to happen at the first
7.	Screw the bottom	hinge in place ensuring
				try), loosen the screws holding the upper
	the door is properly secured.
				hinge, straighten the door and tighten the
8.	Screw the remaining leg to the otl-,er side.
				screws slowly with the socket wrench. After

making sure that the door is installed correctly, tighten all the screws holding the hinge.

If they are not tightened, the door may slip out of position or there may be an opening between the door and the unit.