Problem | Possible | Cause | ||
Won'tIDrain/ | Low voltage | or using | ||
Won't ',,Spin/ | an extension | cord. | ||
Wet Loads |
|
|
|
|
(cont.) | Cold rinses. |
| ||
|
| |||
Continues | Drain hose is less than | |||
to Fill/ | 3!) inches above floor. | |||
Continues |
|
|
|
|
to Drain/ | Drain hose fits tightly into | |||
Cycle Stuck | standpipe. |
|
| |
| Drain hose taped into | |||
| standpipe. |
|
| |
Washer Makes | Load is unbalanced. | |||
Noise | Washer is not level. | |||
| ||||
| Rear leveling legs not set. | |||
| Nuts on front feet not tight. | |||
| Yi_llow shipping strap with | |||
| cotter pins not completely | |||
| removed. |
|
| |
| Floor not strong enough | |||
| to support | washer. | ||
| Gears engaging after drain | |||
| and before spin. | |||
| Upper part of agitator clicks | |||
| during | wash. | ||
Won't Fill/ | Water | inlet valve | ||
Won't Rinse/ | screens are plugged. | |||
Won'tAgitate/ |
|
|
|
|
Wrong | Water | is turned off. | ||
Temperature | Hot and cold hoses are | |||
| ||||
| reversed. |
|
| |
| Inlet hose | is kinked. | ||
| Timer dial is not lined up. | |||
Power cord not plugged in.
Solution
Check electrical source or call
electrician. Do not use extension cords.
Cold rinses leave loads wetter than warm rinses. This is normal.
Raise the drain hose
(see "INSTALLATIONI'Section C).
Adjust drain hose for loose fit
(see "INSTALLATIONI'Section C).
Do not seal off drain hose with tape. The drain hose needs an air gap.
Redistribute load.
Level washer. Reset rear legs (see "INSTALLATION_'Section G).
Tighten nuts
(see "INSTALLATION_'Section G).
Remove strap with cotter pins (see "INSTALLATIONI'Section B).
Relocate washer
(see "INSTALLATIONI'Section A).
This is normal.
This is normal.
Clean screens.
Turn on water.
Reverse hoses (see "INSTALLATIONI' Sections D & E).
Straighten hoses.
Turn timer knob to the right slightly and pull to start.
Plug in power cord.
33
