
Connection of the Power Cable and On/Off Switching
Switch On the Power
1
2
Connect the power cable
The projector will enter the standby mode and
the ON/STANDBY LED will light in red.
To wall outlet.
Press the POWER button ( | ) |
Operation with the | Operation with the |
Projector | Remote Control |
The fan will turn, the lamp will light, and the ON/STANDBY LED will light in green. The LAMP/COVER LED will light in green.
•If the LED lights in red after the POWER button is pressed,
projector trouble is indicated.
→ See Page
•Check that the lens cap has been removed before pressing the POWER button.
The projector is now able to make a projection.
3 Switch on the power of the connected equipment
Switch Off the Power
1
2
Press and hold the POWER button () for 1 second or longer
"Press POWER button again to turn off" will appear on the projection screen.
Press the POWER button () one more time.
The lamp will go off.
• The LAMP/COVER LED flashes green and then goes off after about 60 seconds.
The ON/STANDBY LED lights in resistance.
Operation with the | Operation with the |
Projector | Remote Control |
•When the lamp is off, pressing the POWER button while the LAMP/COVER LED is flashing green will not switch the lamp on again.
To switch the lamp on again, please press the POWER button again after the ON/STANDBY LED lights in red.
3 Disconnecting the Power Cable
The ON/STANDBY LED on the operation panel will go off.
| • | Do not disconnect the power cable while the lamp is on or while the ventilation fan is turning. |
| • | Unplug the power plug of the projector from the wall outlet when the projector will not be used for an |
CAUTION |
| extended period. |
•When the reinserting the power plug into the outlet soon after having unplugged it, please allow a fixed time (of about 10 seconds) before doing so.