Kenwood AT-130 manual Meter Light Power Connection

Accessories:

Carefully unpack your AT-130 Antenna Tuner and verify the following accessories are included.

*Operating manual . . . . . . . . . 1 copy

*Mounting bracket (J29-0402-02) . .1 piece

*Mounting hardware

Screw, 4 mm diameter . . . . . . . 4 pieces Flat washer, 4 mm diameter . . . 4 pieces Lock washer, 4 mm diameter . . 4 pieces Nut, 4 mm diameter . . . . . . . 4 pieces

Wing Bolt, 4 mm diameter

(~09-0007-05) . . .4 pieces Polyethylene washer . . . . . . . 4 pieces

*2P power plug (~09-0203-25). . . .1 piece

*Ground lug (~23 - 0015 - 04).. . . . . 1 piece

Cut end of cable even. Using a sharp knife or razor, score and remove the sheath - Don'tcut the braid.

Interconnection Cable

To connect your- AT-130 with the TS-130S(V). or other transceiver, an interconnection cable is required.

Refer to Figure1-1 for details.

Meter Lamp Power (Figure 1-21

Power for the meter lamp is supplied from an external power source. Use the supplied 2 PIN plug for power-supply connection. Observe pola- rity.

I Figure 1-2.Meter Light Power Connection 1

Slide the coupling over the cable, and carefully solder the connector. Make certain the insulation is not melted by