Troubleshooting Guide

PROBLEM

POSSIBLE CAUSE

SOLUTION

The disc changer mode cannot

No cable has been connected to the

Connect the cable to the disc changer

be selected.

disc changer input terminal on the

input terminal on the unit.

 

unit.

 

 

 

 

The specified disc does not

• The specified CD is very dirty.

• Clean the CD.

play, but another one plays

• The CD is upside-down.

• Load the CD with the labelled side

instead.

 

up.

 

• The disc is loaded in a different slot

• Eject the disc magazine and check

 

from that specified.

the number for the specified disc.

 

• The disc is severely scratched.

• Try another disc instead.

 

 

 

The sound skips.

• Something is touching the disc

 

changer.

 

• The CD is scratched or dirty.

 

• The unit is mounted at a slant.

 

• Changer unit is mounted in an

 

unstable place.

 

• The angle adjustment switches are

 

set improperly.

•Remove whatever is touching it.

•If skipping happens at the same place when the car is stopped, something is wrong with the CD. Clean the CD.

•Mount the unit so that is level.

•Mount the unit in a stable place.

•Set the angle adjustment switches to the correct positions.

The display shows that the changer is being played, but no sound can be heard.

The computer chip in the unit is not

Press the reset button on the unit .

functioning normally.

 

The specified track does not

Random play or magazine random

Turn off the random play or magazine

play.

play has been selected.

random play function.

 

 

 

When removing the CD changer, be sure to first eject a magazine then unplug the changer cord. Do not forget to attach the transport screws before transporting the CD changer.

The CD changer may be damaged during transport if a magazine or CD is left inside it or the transport screws are not attached.

The following indications are used to inform you that there is a problem with the connections of the system.

BUS-E50: Two or more center units are connected.

BUS-W02: The No. switch of the connected disc changers is set to the same number (1 or 2) for both units.

 

] Set the No. switch of one disc changer to "1" and the other unit to "2" to enable proper

 

use.

EJECT:

There is no magazine in the disc changer, or the magazine is not completely inserted.

NO DISC:

There are no discs in the magazine of the disc changer.

ERROR 04:

• The disc is very dirty.

•The disc is upside down.

•The disc has a lot of scratches.

•There is no disc inserted.

•There is no tray in the disc magazine.

READING: The disc data is being read.

]Regular play is permitted when reading of the disc data is completed. ERROR 77: The unit is not operating properly for some reason.

]Press the reset button of this unit. If the "ERROR 77" indication is still displayed, please contact your Kenwood dealer.

ERROR 99: • There is a fault with the disc magazine.

 

• The unit is not operating properly for some reason.

 

] Take out the disc magazine and check the disc magazine interior. If there is no fault

 

with the disc magazine, press the reset button of this unit. If the "ERROR 99"

 

indication is still displayed, please contact your Kenwood dealer.

HOLD:

When the internal temperature of the disc changer becomes 60°C or greater, a protection

 

circuit is activated and the unit may stop working. This indication will be displayed at such

 

a time.

 

] This indication will go out a little while after the temperature of the installation location

 

has dropped.

15