Kenwood CO606 manual know your table top, safety, using your table top can opener, appliance

			know your table top
			can opener
			Your Kenwood Can Opener can be
￿
			used to open a variety of domestic
			can shapes and sizes. In addition the
	￿		CO606 incorporates a bottle opener
			and a knife sharpening facility.
			before using your Kenwood
			appliance
		￿	● Read these instructions carefully
			and retain for future reference.
			● Remove all packaging and any
			labels.

￿			safety
			● Do not immerse appliance, cord or
		￿		plug in water or other liquid.
			● Never use a damaged appliance.
				Get it checked or repaired: see
				‘service and customer care’.
￿			●	Unplug the appliance from the
				mains supply
				●	before cleaning
				●	immediately after use.
	￿		●	This appliance is not intended for
				use by persons (including children)
￿				with reduced physical, sensory or

mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

● Children should be supervised to ensure that they do not play with the appliance.

● Only use the appliance for its intended domestic use. Kenwood will not accept any liability if the appliance is subject to improper use, or failure to comply with these instructions.

before plugging in

●Make sure your electricity supply is the same as the one shown on the underside of your can opener.

Important – UK only

●The wires in the cord are coloured as follows:

Blue = Neutral, Brown = Live.

●The appliance must be protected by a 3A approved (BS1362) fuse.

Note:

●For non-rewireable plugs the fuse cover MUST be refitted when replacing the fuse. If the fuse cover is lost then the plug must not be used until a replacement can be obtained. The correct fuse cover is identified by colour and a replacement may be obtained from your Kenwood Authorised Repairer (see Service).

●If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY.An electric shock hazard may arise if an unwanted non-rewireable plug is inadvertently inserted into a 13A socket outlet.

●This appliance conforms to EC directive 2004/108/EC on Electromagnetic Compatibility and EC regulation no. 1935/2004 of 27/10/2004 on materials intended for contact with food.

key

￿bottle opener

￿drive wheel

￿magnet

￿lever

￿cutter blade

￿guide pin

￿knife sharpener

￿cord stowage

using your table top can opener

1Ensure that the lever is in position with the magnet housing fully located (Fig. 1 and 2).

2Plug the appliance into the power supply.

3Lift the lever to the open position.

4Hold the can with the top rim resting under the metal guide pin and the can resting on the drive wheel (Fig. 3).

5Press the lever lightly down to start the motor. The self-starting blade will then pierce the can and commence cutting.

6The can will be held fixed in position with the magnet resting against the lid. Large or wide cans may require extra support from the user.

7Once the can is open, the motor will automatically stop, retaining the can and lid safely in place.

8To remove, lift the lever whilst holding the can.

9With the exception of aluminium cans, the lid will be retained by the magnet.

10For tidiness, any unwanted length of cord can be stowed inside the appliance.

using the bottle opener

When opening tall bottles, the unit should be used towards the edge of a work top.

1Position the bottle with the cap under the front rim of the bottle opener.

2Push down the bottle to remove the cap whilst steadying the unit with one hand.

Fig. 1

Fig. 2

Fig. 3