Removing Monitor Unit

■Removing the Hard Rubber Frame (escutcheon)

1. Engage the catch pins on the removal tool 5 and remove the two locks on the lower level. Lower the frame and pull it forward as shown in the figure.

2.When the lower level is removed, remove the upper two locations.

The frame can be removed from the top side in the same manner.

Removal Tool (Accessory 5)

Catch

Lock

■Removing the Unit

1.Remove the hard rubber frame by referring to the removal procedure in the section <Removing the Hard Rubber Frame>.

2.Remove the Hex-head screw with integral washer (M4 × 8) on the back panel.

3.Insert the two removal tools 5 deeply into the slots on each side, as shown.

4.Lower the removal tool toward the bottom, and pull out the unit halfway while pressing towards the inside.

Be careful to avoid injury from the catch pins on the removal tool.

5.Pull the unit all the way out with your hands, being careful not to drop it.

Removal Tool (Accessory 5)

English 11