Accessories
1 9
..........1.......... | 6 |
2 0
..........1.......... | 1 |
3 !
..........1 | DNX9960 only |
..........1 | |
4 | @ |
..........1 | DNX9960 only |
..........1 | |
5 | # |
..........2 | ..........1 |
6 | $ |
..........1 | DNX9960 only |
..........1 | |
7 | % |
..........1 | DNX9960 only |
..........1 | |
8 |
|
..........6 |
|
Installation Procedure
1.To prevent a short circuit, remove the key from the ignition and disconnect the - battery.
2.Make the proper input and output wire connections for each unit.
3.Connect the speaker wires of the wiring harness.
4.Connect the wiring harness wires in the following order: ground, battery, ignition.
5.Connect the wiring harness connector to the unit.
6.Install the unit in your car.
7.Reconnect the - battery.
8.Press the reset button.
9.Perform the Initial Setup. (Refer to the Instruction Manual.)
2WARNING
•If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box.
•Do not cut out the fuse from the ignition wire (red) and the battery wire (yellow). The power supply must be connected to the wires via the fuse.
Acquiring GPS Signals
The first time you turn on DNX9960, you must wait while the system acquires satellite signals for the first time. This process could take up to several minutes. Make sure your vehicle is outdoors in an open area away from tall buildings and trees for fastest acquisition. After the system acquires satellites for the first time, it will acquire satellites quickly each time thereafter.
About the Front Panel
When removing the product from the box or installing it, the front panel may be positioned at the angle shown in (Fig. 1). This is due to the characteristics of mechanism the product is equipped with.
When the product is first powered on works
2DNX SERIES/ DDX SERIES