Kenwood DF520 know your Kenwood deep fryer safety, know your Kenwood fryer, before plugging in

know your Kenwood deep fryer

safety

●Never plug in the fryer before filling the bowl with oil.

●Keep children away during use and after - fat stays hot for a long time.

●Never let the cord touch hot surfaces or hang down over the worktop edge - a child could grab it and pull the fryer down. Place excess cord in cord storage area at the back of the fryer.

●Never touch the bowl, pour away oil or move your fryer while the oil’s hot.

●Never put the electrics unit in water. Remove it before washing the rest of your fryer.

●After cleaning, ensure the bowl and its electric pins are dry before use.

●Never leave your fryer on unattended.

●Take care when removing the electrics unit - the temperature probes may be hot.

●Do not use if there is any damage to the fryer, cord or plug. Get it checked or repaired: see ‘service’.

●Only use the electrics unit supplied.

●Watch out for steam during cooking and when you open the lid.

●Never put your fryer near or on cooker hot plates.

●Always unplug the fryer after use.

●This appliance is not intended to be operated by means of an external timer or separate remote-control system.

●This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

●Children should be supervised to ensure that they do not play with the appliance.

●Only use the appliance for its intended domestic use. Kenwood will not accept any liability if the appliance is subject to improper use, or failure to comply with these instructions.

before plugging in

●Make sure your electricity supply is the same as the one shown on the underside of the electrics unit.

Important – UK only

●The wires in the cord are coloured as follows: Green and Yellow = Earth,

Blue = Neutral, Brown = Live.

●The appliance must be protected by a 13A approved (BS1362) fuse.

●WARNING: THIS APPLIANCE MUST BE EARTHED.

Note:

●For non-rewireable plugs the fuse cover MUST be refitted when replacing the fuse. If the fuse cover is lost then the plug must not be used until a replacement can be obtained. The correct fuse cover is identified by colour and a replacement may be obtained from your Kenwood Authorised Repairer (see Service).

●If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY.An electric shock hazard may arise if an unwanted non-rewireable pug is inadvertently inserted into a 13A socket outlet.

●This appliance conforms to EC directive 2004/108/EC on Electromagnetic Compatibility and EC regulation no. 1935/2004 of 27/10/2004 on materials intended for contact with food.

before using for the first time

1Remove all packaging.

2Dismantle: see ‘to dismantle, assemble and use your fryer’.

3Wash the parts: see ‘cleaning’.

know your Kenwood fryer

￿removable lid with permanent mesh filter

￿viewing window

￿lid seal

￿condensation trap

￿rise and fall control

￿pouring lips

￿removable bowl

￿lid release

￿carrying handles

￿electrics unit

￿timer

￿temperature control with neon light

￿temperature probes

￿cord storage

2