DP-R7090/R6090 (En)

5

Connection to a general-use amplifier

Use the provided audio cords to connect the OUTPUT jacks of this unit to the CD input jacks (or AUX jacks) of the amplifier.

Connection to digital amplifier or MD

Connect the DIGITAL OUTPUT (OPTICAL or COAXIAL) jack to the digital input jack of the amplifier, DAT recorder, MD recorder, etc., using an optical fiber cable or coaxial cable which are commercially available in audio stores.

ÖWhen using an optical fiber cable to connect this unit to a digital

Optical fiber cable

amplifier, insert the plug straight into the jack until a snap sound is

 

heard.

 

ÖBe careful not to bend, coil, or bundle the optical fiber cable.

ÖOptical fiber cables available on the market may not always be able to be used with this player. If your cord cannot be used with this unit, consult the store from which you purchased the cord or your nearest dealer.

Adjusting the output levels of the output jacks and headphone output

The OUTPUT level (UP/DOWN) keys of the remote control unit can adjust the output levels from the LINE/OUT and PHONES jacks of the unit.

OUTPUT

DOWN UP

To use the headphone

Connect a stereo headphone to the PHONES jack of the CD player. Adjust the sound volume using the remote control unit.

Output level

OUTPUT -12dB

ÖIt is not favorable for the sound quality to decrease the output level from this unit too much. Use these keys for coordination with other line levels.

ÖAdjusting the headphone output level also changes the LINE/OUT level. Do not adjust the output level from this unit particularly during recording.

ÖPlease note that the sound output is at the maximum level when the power is turned on.