Specifications
|
| |
| [Format] |
|
32 | System ......................................... | Compact disc digital audio system |
Laser .................................................................... | Semiconductor laser | |
| [D/A Convertors] |
|
| D/A Conversion .............................................................................. | 1 Bit |
| Oversampling ............................................................... | 8 fs (352.8 kHz) |
| [Audio] |
|
| Frequency response ........................................ | 4 Hz ~ 20 kHz, ± 0.5 dB |
| Signal to noise ratio ................................................. | More than 98 dB |
| Dynamic range .......................................................... | More than 96 dB |
| Total harmonic distortion + noise | |
| ............................................................ | Less than 0.004% (at 1 kHz) |
| Channel separation .................................. | More than 92 dB (at 1 kHz) |
| Wow & flutter ...................................................... | Unmeasurable Limit |
| Output level/impedance............................................................................... | 2.0 V/1 kΩ |
| Fixed | |
| Digital output |
|
| Optical ............................................................ | |
|
| (Wave length 660 nm) |
| [General] |
|
| Power consumption ..................................................................... | 10 W |
| Dimensions | W : 440 mm |
|
| H : 173 mm |
|
| D : 479 mm |
| Weight (Net) .................................................................. | 7.4 kg (16.3 lb) |
| 1. | KENWOOD follows a policy of continuous advancements in development. For this reason specifications may be changed without notice. |
Notes | 2. | The full performance may not be exhibited in an extremely cold location (under a |
|
|
For the U.S.A.
FCC WARNING
This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmful interference to radio communications, if it is not installed and used in accordance with the instructions. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
–– Reorient or relocate the receiving antenna.
–– Increase the separation between the equipment and receiver.
–– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
–– Consult the dealer or an experienced radio / TV technician for help.
For the U.S.A.
CAUTION:
Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.
In compliance with Federal Regulations, following are reproductions of labels on, or inside the product relating to laser product safety.
KENWOOD CORPORATION
TOKYO, JAPAN
KENWOOD CORP. CERTIFIES THIS EQUIPMENT CONFORMS TO DHHS REGULATIONS NO. 21 CFR 1040.10, CHAPTER I, SUBCHAPTER J.
Location: Back Panel
For your records
Record the serial number, found on the back of the unit, in the spaces designated on the warranty card, and in the space provided below. Refer to the model and serial numbers whenever you call upon your dealer for information or service on this product.
Model |
| Serial Number |