To pause recording (Main unit only)
Lit
TAPE A/B REC/ARM
÷Pressing the key pauses recording after leaving a non- recorded space of about 4 seconds.
÷If the key is pressed again in less than 4 seconds after it has been pressed, recording resumes from that instant.
÷This unit cannot record on a
÷Remove tape slack before loading.
÷When recording is started, the tape is transported in the direction selected in this step.
÷Wind the tape to the position where recording is to be started.
Check the tape transport direction indicator. °XD SERIES (En)
Selection of reverse mode
1Select the “Tape Options”.
MENU | SELECT |
2Select the “Reverse Mode”.
SELECT
3Select desired mode.
| SELECT |
|
| 1 “ | ” ........ Recording stops after having recorded | Operation |
| one side of tape. | |
|
| |
| 2 “ | ” ...... Recording stops after having recorded |
|
| both sides of tape. |
|
| 3 “ | ” ..... Recording stops after having recorded |
|
| both sides of tape. |
|
÷ When the “2” transport direction indicator is lit, recording always stops after having recorded one side of tape.
The input source component
C D 0 1 1 :21 to be recorded should be dis- played.
÷If a disc has already been loaded when the CD input is selected, it will starts to play automatically. In this case, press the stop (7) key to stop it.
÷Even if deck A is selected, it is automatically switched to deck B at the start of recording.
÷Recording stops automatically when the tape side(s) to be recorded have been fully recorded.
÷Press the stop (7) key of the cassette deck unit to stop recording.
The unit is equipped with handy functions for recording from a CD. For details, refer to page 29.
Beat cancel functionThere may be cases in which beat noise interferes with recording of AM (MW)/LW broadcasting.
Switch to "Beat Cancel" before recording the program you want to record. Make a trial recording and then record where the transmission noise is lowest.
1Start recording an AM broadcast.2 Press the Tape A/B key.TAPE A/B | 1 “Beat Cansel on” |
| 2 “Beat Cansel off” |