Installation (for HONDA ACURA Car)
■Installation type 1
■ Installation type 2
English
1Use Accessory1 to attach the unit which was assembled in Assembly.
2Install the center panel with the unit in your car.
NOTE
1 Attach Accessory8 which | 2 Remove the |
was assembled in | car stereo and install the unit. |
Assembly. |
|
Accessory1 (M5 ⋅ 6 mm)
NOTE
The illustration shows an example of installation using a vehicle bracket. The shape of the bracket varies with the vehicle to be installed. Some bracket requires three screws (Accessory1) on each side.
Accessory8 is to be fixed either to the center or bottom, depending on the car model.
Accessory0 (M5 ⋅ 6 mm)
Accessory8
Accessory9 (M3 ⋅ 6 mm)
Accessory! (M5 ⋅ 10 mm)
If accessories 6 and 7 hit the inside of the console, preventing the unit from being attached tightly, snap their end parts off as shown below.shipped with the unit, as shown above.
Accessory67
2CAUTION
Be careful not to get injured with the new edge.
■Installation type 3
1 | Attach Accessory@ to | 2 | Remove the |
| Accessory8 which was |
| car stereo and install the unit. |
| assembled in Assembly. |
| |
Accessory0 |
| car stereo | |
|
| ||
(M5 | ⋅ 6 mm) |
|
|
| Accessory8 |
| |
|
|
| |
|
|
| |
Accessory9 | Accessory! |
| ||
(M3 | ⋅ 6 mm) | (M5 | ⋅ 10 mm) | Reuse the screws |
|
|
|
| |
| Accessory@ |
|
| that were removed. |
— 32 —