— 33 —
What might seem to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Beforecalling service, first check the following table for possible problems.SOLUTIONPOSSIBLE CAUSEPROBLEM
The tape head is dirty. Clean the tape head, referring to the section on "Cleaning
the tape head" (see p. 4).
No sound can be heard, or the
volume is low. The fader or balance settings are set all the way to one side. Reset the fader or balance settings.
The input/output wires or wiring harness are connected
incorrectly.
Reconnect the input/output wires or the wiring harness
correctly. See the section on "Connecting Wires to
Terminals".
The cassette tape is bad. Try playing another cassette tape. If works fine, the first
tape was bad.
Nothing happens when the
buttons are pressed.
The computer chip in the unit is not functioning normally. Press the reset button on the unit (see p. 4).
The sound quality is poor or
distorted.
The speakers are not wired correctly. Reconnect the speaker wires so that each output terminal is
connected to a different speaker.
One of the speaker wires is being pinched by a screw in
the car.
Check the speaker wiring.
The antenna control wire is not connected. Connect the wire correctly, referring to the section on
"Connecting Wires to Terminals".
Radio reception is poor. The car antenna is not extended. Pull the antenna out all the way.
The power does not turn on. The fuse has blown. After checking for short circuits in the wires, replace the
fuse with one with the same rating.
Attenuator is turned on. Turn off Attenuator.
Troubleshooting GuideThe tape does not go in. /
No sound can be heard even
though the tape display is
made.
The car ignition was turned off during tape eject; or the
tape was pulled out during loading, switching the mode
to tape mode even though no tape is in.
Press the Eject button.
The memory is erased when
the ignition is turned off.
The battery wire has not been connected to the proper
terminal.
Connect the wire correctly, referring to the section on
"Connecting Wires to Terminals".
Connect the wire correctly, referring to the section on
"Connecting Wires to Terminals".
The ignition and battery wire are incorrectly connected.
A CD ejects as soon as it is
loaded.
The CD is upside-down. Load the CD with the labeled side up.
The CD is quite dirty. Clean the CD, referring to the section on "Cleaning CDs"
(see p. 5).
The sound skips on a CD. The CD is scratched or dirty. Clean the CD, referring to the section on "Cleaning CDs"
(see p. 5).