Kenwood FP260 Series manual safety, before using your Kenwood appliance, before plugging in

before using your Kenwood appliance

●Read these instructions carefully and retain for future reference.

●Remove all packaging and any labels.

safety

●The blades and discs are very sharp, handle with care. Always hold the knife blade by the finger grip at the top, away from the cutting edge, both when handling and cleaning.

●Always remove the knife blade before pouring contents from the bowl.

●Keep hands and utensils out of the processor bowl and liquidiser goblet whilst connected to the power supply.

●Switch off and unplug:-

●before fitting or removing parts;

●when not in use;

●before cleaning.

●Never use your fingers to push food down the feed tube. Always use the pusher/s supplied.

●Before removing the lid from the bowl or liquidiser/mill from the power unit:-

●switch off;

●wait until the attachment/blades have completely stopped;

●be careful not to unscrew the liquidiser goblet or mill jar from the blade assembly.

●Liquids should be allowed to cool to room temperature before blending.

●Do not use the lid to operate the processor, always use the on/off speed control.

●This machine will be damaged and may cause injury if the interlock mechanism is subjected to excessive force.

●Never use an unauthorised attachment.

●Never leave the appliance unattended when it is operating.

●Never use a damaged appliance. Get it checked or repaired: see ‘service and customer care’.

●Never let the power unit, cord or plug get wet.

●Don’t let excess cord hang over the edge of a table or worktop or touch hot surfaces.

●Do not exceed the maximum capacities stated in the recommended speed chart.

●This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

●Children should be supervised to ensure that they do not play with the appliance.

●Only use the appliance for its intended domestic use. Kenwood will not accept any liability if the appliance is subject to improper use, or failure to comply with these instructions.

●Misuse of your processor/liquidiser can result in injury.

Refer to the relevant section under “using the attachments” for additional safety warnings for each individual attachment.

before plugging in

●Make sure your electricity supply is the same as the one shown on the underside of your machine.

Important – UK only

●The wires in the cord are coloured as follows: Green and Yellow = Earth,

Blue = Neutral, Brown = Live.

●The appliance must be protected by a 13A approved (BS1362) fuse.

●WARNING: THIS APPLIANCE MUST BE EARTHED. Note:

●For non-rewireable plugs the fuse cover MUST be refitted when replacing the fuse. If the fuse cover is lost then the plug must not be used until a replacement can be obtained. The correct fuse cover is identified by colour and a replacement may be obtained from your Kenwood Authorised Repairer (see Service).

●If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY.An electric shock hazard may arise if an unwanted non-rewireable pug is inadvertently inserted into a 13A socket outlet.

●This appliance conforms to EC directive 2004/108/EC on Electromagnetic Compatibility and EC regulation no. 1935/2004 of 27/10/2004 on materials intended for contact with food.

before using for the first time

1Remove all packaging including the plastic blade covers from the knife blade. Take care the blades are very sharp. These covers should be discarded as they are to protect the blade during manufacture and transit only.

2Wash the parts see ‘cleaning’

3Push excess cord into the back of the machine.

2