troubleshooting guide
Problem | Cause | Solution |
The processor will not operate. | No Power. | Check processor is plugged in. |
| Bowl not fitted to power unit correctly. | Check bowl is located correctly and |
|
| the handle is situated towards the |
|
| right hand side. |
| Bowl lid not locked on correctly. | Check that the lid interlock is |
|
| located correctly into the handle |
|
| area. |
|
| The processor will not work |
|
| if the bowl and lid are fitted |
|
| incorrectly. |
|
| If none of the above check the |
|
| fuse/circuit breaker in your home. |
|
|
|
Liquidiser or mini chopper/mill will not operate | Liquidiser or mini chopper/mill not locked | The liquidiser or mini chopper/mill will |
| on correctly. | not operate if fitted incorrectly to the |
|
| interlock. |
| Liquidiser or mini chopper/mill not assembled | Check blade unit is fully tightened |
| correctly. | into the goblet/jar. |
|
|
|
Processor stops during | Processor overloaded/maximum capacities | Check maximum capacities stated |
processing | exceeded. | in the recommended speed chart. |
| Lid unlocked. | Check lid is locked correctly. |
|
|
|
Liquidiser or mini chopper/mill leaking from | Seal missing | Check seal is fitted correctly and not |
blade assembly base. | Seal incorrectly fitted | damaged. To obtain a replacement |
| Seal damaged. | seal see “service & customer care” |
|
|
|
Poor performance of tools/attachments | Refer to hints in relevant “using the attachment” section. Check attachments are | |
| assembled correctly. |
|
8
