29
Basic section
MD
REC
0001 0:0001JA54:32 WR
STOP
7
TRACK EDIT
Recording on MD

Pause the recording

The recordable time for the MD is displayed.
Blinks
÷Press the key again to resume recording. At this time,
the track number is incremented by “1”.
÷Recording can also be started by pressing the MD rec
key.
In regard to track numbers at the time of recording
Press during recording.
When a part without sound continues for 2 sec. or
more during recording, the track number is automati-
cally increased by “1” when the next sound enters.
When classic music continues with low sound, the
track number may be increased by “1”. (The track
number is not increased during recording of the tape
or tuner input.)
The erroneously set track number can be erased later.
When it is desired to increase the track No. during
recording, press the TRACK EDIT key during record-
ing to record a track No. at that position.
The track numbers are used at the time of playback to
find the start of tracks, for programming, etc.
÷With digital recording from a CD, the track number is
increased when the track changes.
NoteNote
Note
At the time of recording from a CD, the track
number may be incremented when CD playback
starts. This occurs because of a signal included in
the digital signal from the CD. Delete unwanted
track numbers under reference to “TRACK ERASE
or ALL ERASE”.p
÷Do not turn power off or apply shock or impact while
“WRITING” is displayed. If the power cord is unplugged
before “WRITING” disappears, the recorded or edited
data will be lost.

3. Start recording.

1Press the MD rec key (the unit enters record-pause mode).2When the preparation is complete, press the MD rec key again.3Play the music source to be recorded.
÷When recording a CD, if CD6 key is pressed after step 1, the MD starts
recording at the same time as the CD starts to be played. q

In regard to display messages

Recording is not possible when one of the following messages is displayed.
“DISC FULL” : The minidisc is full. \ Erase unrequired tracks. p
“PROTECTED” : The write protect tab is open. \ Close it. ˇ
“PLAY ONLY” : The minidisc is only for playback. \ Insert a recordable disc.

Stop the recording

6
MD
MD
rec
33