Installation

Remote cable

Self-tapping screw

(ø4 16 mm)

Cooling fan

Installation board, etc. (thickness : 15 mm or more)

2CAUTION

Remote controler (KAC-7251 only)

Double-side tape

Remote controler

 

OFF

+6

dB

 

 

+9

 

Knob

 

+12

 

 

 

 

 

 

Self-tapping screw

 

 

(ø3 12 mm)

 

 

 

Dressing plate

 

Washer

 

Nut

 

 

 

NOTE

 

+6 dB

+9

 

 

OFF

+12

Mount the Dressing plate

 

according to the mount

 

angle of the Remote

 

Controller.

 

 

 

Fully rotate the knob

 

counterclockwise (CCW), and adjust the

 

marking of the knob to the "OFF" position of the Dressing plate.

Do not install in the below locations;

(Unstable location, In a location that interferes with driving, In a location that gets wet, In a dusty location, In a place that gets hot, In a place that gets direct sunlight, In a location that gets hit by hot air)

Do not install the unit under the carpet. Otherwise heat build-up occurs and the unit may be damaged.

Install this unit in a location which allows heat to easily dissipate. Once installed, do not place any object on top of the unit.

The surface temperature of the amplifier will become hot during use. Install the amplifier in a place where people, resins, and other substances that are sensitive to heat will not come into contact with it.

This unit has cooling fans to decrease the internal temperature. Be careful not to block the cooling fan openings when installing the unit. Blocking these openings will inhibit the cooling of the internal temperature and result in malfunction.

When making a hole under a seat, inside the trunk, or somewhere else in the vehicle, check that there is nothing hazardous on the opposite side such as a gasoline tank, brake pipe, or wiring harness, and be careful not to cause scratches or other damage.

Do not install near the dashboard, rear tray, or air bag safety parts.

The installation to the vehicle should securely fasten the unit to a place in which it will not obstruct driving. If the unit comes off due to a shock and hits a person or safety part, it may cause injury or an accident.

After installing the unit, check to make sure that electrical equipment such as the brake lamps, turn signal lamps and windshield wipers operate normally.

English 3