Troubleshooting Guide
What might appear to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems.
PROBLEM | POSSIBLE CAUSE | SOLUTION |
No sound. | • Input (or output) cables are |
(No sound from one side.) | disconnected. |
| • Protection circuit may be |
| activated. |
| • The fuse may be blown because |
| the volume was too high. |
•Connect the input (or output) cables.
•Check connections by referring to "Indicator".
•Replace the fuse with a new fuse and use a lower volume.
The output level is too small (or too large).
The input sensitivity adjusting | Adjust the control correctly |
control is not set to the correct | referring to “Controls”. |
position. |
|
The sound quality is bad. (The sound is distorted.)
•The speakers cable are connected with wrong + / - polarity.
•A speaker cable is pinched by a screw in the car body.
•The switches may be set improperly.
•Connect them properly checking the + / - of the terminals and cables well.
•Connect the speaker cable again so that it is not pinched by anything.
•Set switches properly by referring to "System examples".
If the slide panel moves of its own accord.
•The system is in DEMO mode.
•The slide panel has gone into remote operation mode.
•Cancel DEMO mode by pressing the OPEN/CLOSE button.
•Check the B.M.S. and operate the slide panel remotely or manually.
The external amplifier | • The B.M.S. switch is set to |
controller (B.M.S.) will not | "B.M.S. (+6)". |
work. | • The external amplifier control |
| cable has come loose. |
•The B.M.S. switch is set to "(REMOTE)".
•Check that the external amplifier control cable is properly connected.
14English