B.M.S. (Bass Management System)
COOLING FAN
AIR
INDUCTION
OPERATION/PROTECTION
4/3/2 CHANNEL POWER AMPLIFIER | POWER |
OPEN/CLOSE
LOW VOLTAGE
B.M.S.
B | SENSITIVITY(V)INPUT | 2 | 3 | 4 | 0.5 | FREQ (Hz) | (MAX)(MIN) | HPFLPF OFF 25Hz OFF 15Hz | INFRASONIC |
5 0.2 | |||||||||
|
|
| 1 |
|
|
|
|
|
|
CONTROL | B.M.S. |
|
|
| 50 100 |
| B.M.S. ( | FILTER | |
|
| 80 |
|
|
|
|
| +6) |
|
| EXT.AMP.CONT. FREQ(Hz) | (REMOTE) | OPEN/ B.M.S. CLOSE |
| STEREO MONO | OPERATION B.M.S. | |||
| P.CON |
|
|
|
|
|
|
| |
| L |
|
|
| R |
|
|
|
|
|
|
|
|
|
|
|
| A + B | LINE OUT |
|
|
|
|
|
|
|
| B |
|
|
|
|
|
|
|
|
|
| LINE IN |
|
|
|
|
|
|
|
| A |
|
MONO | L |
|
|
|
| R |
| A | SELECT |
|
| GND |
|
|
|
|
| AB | INPUT |
CONTROL | SENSITIVITY(V)INPUT |
|
|
|
| (Hz)FREQ | (MIN)(MAX) | STEREO MONO | OPERATION |
2 | 3 | 4 |
| OFF25Hz HPF LPF 15Hz OFF | INFRASONICFILTER | ||||
A |
|
|
|
|
|
|
|
|
|
|
|
| 1 |
| 0.5 0.2 |
|
|
| |
|
|
|
|
|
| 5 |
|
|
|
B.M.S. |
| 80 |
FREQ(Hz) |
| |
(REMOTE) |
|
|
OPEN/ B.M.S. |
| |
CLOSE | 50 | 100 |
| ||
B.M.S. (+6)
B.M.S.
OPERATION/PROTECTION
OPEN/CLOSE
LOW VOLTAGE
B.M.S.
2
1
3
B.M.S. indicator
■If the unit is not going to be operated from the outside:
1B.M.S. switch
This boosts the bass, focusing mainly on the frequency setting determined using the B.M.S. FREQUENCY control.
The bass boost applies only to the B amplifier.
•(REMOTE) OPEN/CLOSE or
(REMOTE) B.M.S. position:
When the switch is in this position, the bass is not boosted.
Bass boost | Flat (OFF) | |
Slide panel | Operations using the | |
OPEN/CLOSE button | ||
|
•B.M.S. (+6) position:
When the switch is in this position, the bass is boosted by 6dB.
The B.M.S. indicator glows.
Bass boost | +6dB (ON) | |
Slide panel | Operations using the | |
OPEN/CLOSE button | ||
|
NOTE
•If the slide panel meets an obstacle whilst sliding, the slide operation will be halted. If this happens, remove the obstacle and then press the OPEN/CLOSE button again.
•If the centre unit power is switched OFF, or the vehicle engine is switched OFF, whilst the slide panel is open, the slide panel will then close automatically. The next time the power is turned ON or the vehicle engine is turned ON, the slide panel will return to its original open state.
•If the B.M.S. switch setting is changed to (REMOTE), the slide panel will close in preparation for remote operation, even if the EXT.AMP.CONT. terminal is not connected.
2CAUTION
Take care not to allow your finger or any other object to be trapped by the slide panel whilst it is sliding.
2B.M.S. FREQUENCY control
When the B.M.S. switch is set to the B.M.S. (+6) position, this control can be used to adjust the central frequency that you want to emphasise.
3OPEN/CLOSE button
Each time you press this button, the slide panel either opens or closes.
6English