Kenwood KCA-R42FM

— 11 —

Accessories

External view

......... Number of items

.........1

.........2

The use of any accessories except for those provided might result

in damage to the unit. Make sure only to use the accessories

shipped with the unit, as shown above.

2CAUTION

.........1

1. To prevent a short circuit, remove the key from the ignition and

disconnect the -battery.

2. Make the proper input and output wire connections for each unit.

3. Connect the wiring harness wires in the following order: ground,

battery, ignition.

4. Install the unit in your car.

5. Reconnect the -battery.

6. Press the reset button.

When drilling a hole in the car chassis to install the unit, check

first that nothing is on the other side.

•If the fuse blows, first make sure the wires aren’t touching to

cause a short circuit, then replace the old fuse with one with the

same rating.

•Do not let unconnected wires or terminals touch metal on the car

or anything else conducting electricity. To prevent a short circuit,

do not remove the caps on the ends of the unconnected wires or

the terminals.

•After the unit is installed, check whether the brake lamps, blinkers,

wipers, etc. on the car are working properly.

•Insulate unconnected wires with vinyl tape or other similar

material.

•Some disc changers need conversion cords for connection. See

the section on "Safety Precautions" for details.

2CAUTION

2WARNING

Installation Procedure

KCA-R42FM_U.S(K/En) 02.12.16 9:13 AM Page 11