English
What might appear to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems.
| PROBLEM | POSSIBLE CAUSE | SOLUTION | |
|
|
| |
The power does not turn on. | The fuse has blown. | After checking for short circuits in the cables, replace the | |
|
| fuse with one having the same rating. | |
|
|
| |
| No ACC position on vehicle ignition. | Connect the same cable to the ignition as the battery cable. | |
|
|
| |
No sound can be heard, or the | The Attenuator function is turned on. | Turn off the Attenuator function. | |
volume is low. |
|
| |
The fader and/or balance settings are set all the way to | Reset the fader and/or balance settings. | ||
| |||
| one side. |
| |
|
|
| |
| The input/output cables or wiring harness are connected | Reconnect the input/output cables and/or the wiring harness | |
| incorrectly. | correctly. See the section on "Connecting Cables to | |
|
| Terminals". | |
|
|
| |
Nothing happens when the | The computer chip in the unit is not functioning normally. | Press the reset button on the unit (see page 4). | |
buttons are pressed. |
|
| |
|
|
| |
The sound quality is poor or | A speaker cable may be pinched by a screw in the car. | Check the speaker wiring. | |
distorted. |
|
| |
The speakers are not wired correctly. | Reconnect the speaker cables so that each output terminal | ||
| |||
|
| is connected to a different speaker. | |
|
|
| |
Radio reception is poor. | The car antenna is not extended. | Pull out the antenna all the way. | |
|
|
| |
| The antenna control cable is not connected. | Connect the cable correctly, referring to the section on | |
|
| "Connecting Cables to Terminals". | |
|
|
| |
The memory is erased when | The battery cable has not been connected to the proper | Connect the cable correctly, referring to the section on | |
the ignition is turned off. | terminal. | "Connecting Cables to Terminals". | |
|
|
| |
| The ignition and battery cable are incorrectly connected. | Connect the cable correctly, referring to the section on | |
|
| "Connecting Cables to Terminals". | |
|
|
| |
A CD ejects as soon as it is | The CD is | Load the CD with the labelled side up. | |
loaded. |
|
| |
The CD is quite dirty. | Clean the CD, referring to the section on "Cleaning CDs" (see | ||
| |||
|
| page 5). | |
|
|
| |
The sound skips on a CD. | The CD is scratched or dirty. | Clean the CD, referring to the section on "Cleaning CDs" (see | |
|
| page 5). | |
|
|
| |
The specified track does not | Random play has been selected. | Turn off the random play function. | |
play. |
|
|
— 26 —