Connections

D Changer control cable (5m)

F Harness ties

Fix the harness tie close to its connector.

�

��

��

Control unit (optional)

Monitor unit (optional)

�

�

 

To parking brake detection

 

 

EVideo cable (Black) (4m)/

switch harness of car

 

 

 

 

 

Parking senser cable (Green) (6m)

��� ��

 

 

 

"NTSC"

"PAL"

 

For the sake of safety, be sure

 

 

 

to connect the parking sensor.

Picture format selector switch

•Do not connect the changer control cable while the control unit is turned ON.

•Be sure to press the reset button after installation.

•Do not install an antenna of radio equipment or distribute the antenna cable near the changer output cable, for this could cause malfunction with this unit.

The picture format selector switch must be set to the format of the connected monitor.

Set the KDC-CMP21V’s picture format selector switch to "PAL" when a PAL monitor is connected, to "NTSC" when an NTSC monitor is connected.

Use video CDs of the same format as the format to which the KDC-CMP21V is set.

•No picture will appear if the KDC-CMP21V’s video output format is not the same as the monitor’s picture format.

•The top and bottom of the picture may be cut off or a black stripe may appear if the video CD’s format is different from the KDC-CMP21V’s video output format.

Using the Relay Connector (Accessory G)

1 Plug the vehicle's harness into the relay 3 Lock the cable clamp. connector.2Plug the parking brake detection wire into the relay connector.

 

Relay

Cable clamp

Vehicle

 

connector

3

harness

2

 

 

 

1

 

 

Detection wire

 

4Press down using pliers until the conductive metal is even with the plastic surface.

5Lock the lid.

Lid

5

4

Conductive metal

English 13