Accessories

1

.....1

2

.....2

3

.....4

4

.....4

Installation Procedure

1.To prevent a short circuit, remove the key from the ignition and disconnect the - battery.

2.Make the proper input and output wire connections for each unit.

3.Connect the speaker wires of the wiring harness.

4.Connect the wiring harness wires in the following order: ground, battery, ignition.

5.Connect the wiring harness connector to the unit.

6.Install the unit in your car.

7.Reconnect the - battery.

8.Press the reset button.

¤CAUTION

•Keep battery out of reach of children and in original package until ready to use. Dispose of used batteries promptly. If swallowed contact physician immediately.

•Do not leave the battery near fire or under direct sunlight. A fire, explosion or excessive heat generation may result.

•Do not set the remote control in hot places such as on the dashboard.

•Danger of explosion if Lithium battery is incorrectly replaced. Replace only with the same or equivalent type.

10 Quick Start Guide

¤CAUTION

Install this unit in the console of your vehicle.

Do not touch the metal part of this unit during and shortly after the use of the unit. Metal part such as the heat sink and enclosure become hot.