tape or other similar material. To prevent a short circuit, do not remove the caps on the ends of the unconnected wires or the terminals.

•Connect the speaker wires correctly to the terminals to which they correspond. The unit may be damaged or fail to work if you share the - wires or ground them to any metal part in the car.

•When only two speakers are being connected to the system, connect the connectors either to both the front output terminals or to both the rear output terminals (do not mix front and rear). For example, if you connect the + connector of the left speaker to a front output terminal, do not connect the - connector to a rear output terminal.

•After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are working properly.

•Mount the unit so that the mounting angle is 30° or less.

•Reception may drop if there are metal objects near the Bluetooth antenna. (KDC-U7046BT/ KDC-U7046BTL only)

Bluetooth antenna unit

For Good ReceptionTo assure good reception, note the following:

•Communicate with the cell-phone within the line-of-sight distance of 10 m (30 ft). The communication range becomes shorter depending on the surrounding environment. The communication range also becomes shorter when there is an obstacle between this unit and the cell-phone. The above maximum communication range (10 m) is not always assured.

•A broadcast station or walkie-talkie located nearby can interfere with communication due to too strong signal.

¤CAUTION

•Keep battery out of reach of children and in original package until ready to use. Dispose of used batteries promptly. If swallowed contact physician immediately.

•Do not leave the battery near fire or under direct sunlight. A fire, explosion or excessive heat generation may result.

•Do not set the remote control in hot places such as on the dashboard.

•Danger of explosion if Lithium battery is incorrectly replaced. Replace only with the same or equivalent type.

¤CAUTION

Install this unit in the console of your vehicle.

Do not touch the metal part of this unit during and shortly after the use of the unit. Metal part such as the heat sink and enclosure become hot.

English 11