Installation/Removing the Unit

non-Japanese cars

Bend the tabs of the mounting sleeve with a screwdriver or similar utensil and attach it in place.

⁄

•Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (for example, the sound may skip).

Japanese cars

1.Refer to the section <Removing the hard rubber frame> and then remove the hard rubber frame.

2.Align the holes in the unit (two locations on each side) with the vehicle mounting bracket and secure the unit with the accessory screws.

TN

Removing the hard rubber frame

1.Engage the catch pins on the removal tool and remove the two locks on the upper level.

Lift up and pull the frame forward as shown in the figure.

Lock Catch

Removal tool (Accessory2)

2.When the upper level is removed, remove the lower two locations.

⁄

•The frame can be removed from the bottom side in the same manner.

Removing the Unit

1.

Refer to the section <Removing the hard

 

rubber frame> and then remove the

 

hard rubber frame.

2.

Remove the faceplate.

3.

Insert the two removal tools deeply into

 

the slots on each side, as shown.

4.

Lower the removal tool toward the

 

bottom, and pull out the unit halfway

N T

T/N

T: Toyota cars

N: Nissan cars

while pressing towards the inside.

Accessory2

34

8 mm

8mm

MAX.

MAX.

 

ø5mmø5mm

Accessory3...for Nissan car

Accessory4...for Toyota car

¤

•Be careful to avoid injury from the catch pins on the removal tool.

5.Pull the unit all the way out with your hands, being careful not to drop it.

14 Quick Start Guide