The messages shown below display your systems condition.
TOC Error: | • No disc has been loaded in the disc |
| magazine. |
| • The CD is quite dirty. The CD is upside- |
| down. The CD is scratched a lot. |
Error 05: | The disc is unreadable. |
Error 77: | The unit is malfunctioning for some reason. |
| ➪ Press the reset button on the unit. If the |
| “Error 77” code does not disappear, consult |
| your nearest service center. |
Mecha Error: | Something is wrong with the disc magazine. |
| Or the unit is malfunctioning for some reason. |
| ➪ Check the disc magazine. And then press |
| the reset button on the unit. If the “Mecha |
| Error” code does not disappear, consult |
| your nearest service center. |
IN (Blink): | The CD player section is not operating |
| properly. |
| ➪ Reinsert the CD. If the CD cannot be |
| ejected or the display continues to flash |
| even when the CD has been properly |
| reinserted, please switch off the power |
| and consult your nearest service center. |
Protect: | The speaker wire has a |
| touches the chassis of the vehicle, and then |
| the protection function is activated. |
| ➪ Wire or insulate the speaker cable properly |
| and press the reset button. If the “Protect” |
| code does not disappear, consult your |
| nearest service center. |
Unsupported File:
An Audio file is played with a format that this unit can’t support.
Copy Protect:
Copy Protection:
A
Read Error: | The file system of the connected USB device |
| is broken. |
| ➪ Copy the files and folders for the USB |
| device again. If the error message is still |
| displayed, initialize the USB device or use |
| other USB devices. |
No Device: | The USB device is selected as a source |
| although no USB device is connected. |
| ➪ Change the source to any source other |
| than USB. Connect an USB device, and |
| change the source to USB again. |
N/A Device: | An unsupported USB device is connected. |
No Music Data/ Error 15:
•The connected USB device contains no playable audio file.
•Media was played that does not have data recorded that the unit can play.
USB ERROR (Blink):
Some trouble may have occurred to the connected USB device.
➪Remove the USB device, then cycle the power switch to ON. If the same display is repeated, use another USB device.
iPod Error: | Connection to the iPod has failed. |
| ➪ Check that the connected iPod is an iPod |
| that is supported. See <About Audio file> |
| (page 22) for information on supported |
| iPods. |
| ➪ Remove the USB device and then |
| reconnect it. |
| ➪ Confirm that the software for the iPod is |
| the latest version. |
USB REMOVE: | The Remove mode has been selected for the |
| USB device/iPod. You can remove the USB |
| device/iPod safely. |
English 31