English
— 40 —
Make sure that the unit is installed securely in place. If the unit is
unstable, it may malfunction (for example, the sound may skip).
Bend the tabs of the
mounting sleeve with
a screwdriver or similar
utensil and attach it in
place.
Metal mounting strap
(commercially
available)
Phillips truss head
sheet metal screw
(commercially available)
Firewall or metal support
Screw (M4X8)
(commercially
available)
To attach this unit, make sure the front of the control panel faces you
and fit it into the mounting sleeve by pressing the four corners of the
hard rubber frame at the same time.
Do not apply strong pressure to other sections than the corners;
otherwise troubles such as the impossibility of opening or closing the
panel may result.
Installation (non-Japanese cars)
R
L
8mm
5mm
5mm
8mm

For Nissan Car

After aligning the J-Car

bracket with the factory-

installed radio bracket,

tighten the screws.

Accessory4
for Toyota car Accessory3
for Nissan car
Factory trim bezel
Accessory6
J-Car Bracket
(follow indications for L/R)
Accessory7
J-Car Trim Plate
(place thick part on bottom)
Factory-installed
Radio Bracket
Factory-installed
Radio Bracket

For Toyota Car

After aligning the factory-

installed radio bracket,

tighten the screws.

Damage to the unit will result from using screws other than those
provided.
A pair of J-Car Brackets (Accessory 6) are not used when fitting
in a Toyota car.
Installation (Japanese-cars)

KDC-X859_U.S_r1 01.12.10 9:40 AM Page 40