Kenwood KDC-MP7028, KDC-MP728, KDC-MP628, KDC-MP828, KDC-X789, KDC-X889 Display Mode Switching, 3, 5, Graphic part/ Spectrum Analyzer Display Switching, 4

20 | English

General features

Display Mode Switching

Switching the display mode.

1 Select the key function section

Press the [NEXT] button.

Repeatedly press the button until "DISP" is

displayed above the [6] (KDC-X889/MP828)/[2]

(KDC-MP7028/MP728/X789/MP628) button.

Refer to <Notes on Multi-function Key System>

(page 9).

2 Enter display control mode

Press the [6]/[2] ("DISP") button.

3 Select the display mode

Press the [1] ("MODE") button.

4 Select the display Type

Push the Control knob to [4] or [¢].

Each time the knob is pushed, the display mode

switches as shown below.

Display Mode Display

"Display Type A" 1

"Display Type B" 12

"Display Type C" 4

"Display Type D" 4 7

8 8 8 8 8 8

"Display Type E"* 9

1 Graphic display part

2 Text display part

3 Text icon display part

4 Upper text display part

5 Middle text display part

6 Lower text display part

7 Source icon display part

8 Function item display

9 G-Analyzer display part

• * Function of the KDC-X889/MP828/MP7028/MP728/

X789

5 Exit display control mode

Press the [6] ("RTN") button.

• Under the display type other than "Display Type D",

the function item is not displayed. When the display

type other than "Display Type D" is selected, press [1]

to [6] buttons or [NEXT] button. The function item will

be displayed approximately 5 seconds.

• The information can be switched by the Display

Type. Refer to the page on the following table for the

methods to switch by the Display Type.

Display Type

ABCDE

Graphic 120 20 ———

Text 2—22———

Upper 4— — 23 23 —

Middle 5—— 23 ——

Lower 6— — 23 23 —

G-Analyzer 9———— 27

Display Type A/ Display Type B

Graphic part/ Spectrum Analyzer

Display Switching

Switching the graphic Display/ Spectrum analyzer

display.