Installation accessories

1

.....1

2

.....2

3

.....4

4

.....4

5 (KDC-X895, KDC-BT848U only)

.....1 (3m)

10 Quick Start Guide

Before installation

2WARNING

•The unit can only be installed in a car with a 12V DC power supply, negative ground.

•If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box.

¤CAUTION

•Install this unit in the console of your vehicle.

•Do not touch the metal part of this unit during and shortly after the use of the unit. Metal part such as the heat sink and enclosure become hot.

•Mounting and wiring this product requires skills and experience. For safety’s sake, leave the mounting and wiring work to professionals.

•If you experience problems during installation, consult your Kenwood dealer. Disconnect the battery’s negative terminal and make all electrical connections before installing the unit.

•Insulate unconnected wires with vinyl tape or other similar materials. To prevent a short circuit, do not remove the caps on the ends of the unconnected wires or the terminals.

•Be sure to ground this unit to the car’s chassis again after installation.

•If the fuse blows, first make sure the wires are not touching to cause a short circuit, then replace the old fuse with one with the same rating.

•When only two speakers are being connected to the system, connect the connectors either to both the front output terminals or to both the rear output terminals (do not mix front and rear). For example, if you connect the +