connector of the left speaker to a front output terminal, do not connect the - connector to a rear output terminal.

•Connect the speaker wires correctly to the terminals to which they correspond. The unit may be damaged or fail to work if you share the - wires or ground them to any metal part in the car.

•Do not use your own screws. Use only the screws provided. If you use the wrong screws, you could damage the unit.

•If your car’s ignition does not have an ACC position, connect the ignition wires to a power source that can be turned on and off with the ignition key. If you connect the ignition wire to a power source with a constant voltage supply, as with battery wires, the battery may die.

•If the console has a lid, make sure to install the unit so that the faceplate will not hit the lid when closing and opening.

•After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are working properly.

•Mount the unit so that the mounting angle is 30° or less.

•Reception may drop if there are metal objects near the Bluetooth antenna. (KDC-X895, KDC-BT848U only)

For Good Reception

To assure good reception, note the following:

•Communicate with the cell-phone within the line-of-sight distance of 10 m (30 ft). The communication range becomes shorter depending on the surrounding environment. The communication range also becomes shorter when there is an obstacle between this unit and the cell-phone. The above maximum communication range (10 m) is not always assured.

•A broadcast station or walkie-talkie located nearby can interfere with communication due to too strong signal.

Bluetooth antenna unit

English 11