General features

English

Function of the KDC-X915/KDC-X815

“Tre Frq” : Adjust the center frequency of the treble. Setting values: 10.0 / 12.5 / 15.0 / 17.5 kHz

NOTE

This mode is available only when the Sound coordinate system is on. (page 38).

“Tre” : Adjust the treble level.

Setting values: - 8 – + 8

“Balance” : Adjust the balance level. Setting values: Left 15 – Right 15

“Fader” : Adjust the fader level. Setting values: Front 15 – Rear 15

Function of the KDC-X915/KDC-X815

“NFpre Level” : Adjust the Non-fading output level. Setting values: - 15 – + 15

NOTE

Not available during the Dual zone system is on.

Function of the KDC-X915/KDC-X815

"HPF Front" : Adjust the frequency of the High-pass filter for front output.

Setting values: Through / 40Hz / 60Hz / 80Hz / 100Hz / 120Hz / 150Hz / 180Hz / 220Hz

NOTE

You can separately set the high-pass filter for front and rear output,including preouts. The high-pass filter does not affect the non-fading preout. The factory default settings for front output and rear output are "Throu" .

Function of the KDC-X915/KDC-X815

"HPF Rear" : Adjust the frequency of the High-pass filter for rear output.

Setting values: Through / 40Hz / 60Hz / 80Hz / 100Hz / 120Hz / 150Hz / 180Hz / 220Hz

NOTE

You can separately set the high-pass filter for front and rear output,including preouts. The high-pass filter does not affect the non-fading preout. The factory default settings for front output and rear output are "Throu" .

Function of the KDC-X915/KDC-X815

“LPF NFpre” : Adjust the frequency of the Low-pass filter for Non-Fading output.

Setting values: 50 Hz / 80 Hz / 120 Hz / Through

NOTE

Not available during the Dual zone system is on.

— 10 —