Audio Control Setting
Adjust various parameters of sound quality.
1Press the AUD button to enter the control mode.
2Selecting mode
Press either the FM or AM button.
Each time the button is pressed, the adjustment mode will change.
Please refer to the following for the contents of the adjustment modes.
NOTE Source tone memory
Each source (CD, FM, AM and disc changer ) has its own memory in which to store the bass, treble and
3Adjust each mode
Press the 4/¢ button.
Please refer to the following for the adjusting values.
4Press the AUD button to end the control mode.
"Kex"/"ec4" : Recalling the kenwood preset sound setting Press the preset buttons
Settings: #1;Flat, #2;Rock, #3;Top40, #4;Jazz, #5;Easy, #6;Scan of
NOTE
•This mode is available only when the Sound coordinate system is on. (page 38)
•You can call the following settings with this function; bass center frequency, bass level, bass quality factor, bass extension, treble center frequency, and treble level setting. Their setting values are different depending on the setting of the mobile preset plan
Function of the
“Bass Frq” : Adjust the center frequency of the bass.
Setting values: 60 / 70 / 80 / 100 (Only when the bass quality factor is set to 1.0, 1.25 or 1.5) / 150 (Only when the bass quality factor is set to 2.0) Hz
NOTE
This mode is available only when the Sound coordinate system is on. (page 38)
“Bass” : Adjust the bass level. Setting values: - 8 – + 8
Function of the
“Bass Q” : Adjust the Bass quality factor. Setting values: 1.00 / 1.25 / 1.50 / 2.00
NOTE
This mode is available only when the Sound coordinate system is on. (page 38)
Function of the
“Bass EXT” : Switch the Bass Extend mode on/off.
Setting values: ON / OFF
(When the bass extend mode is set to on, low frequency response is extended by 20%.)
NOTE
This mode is available only when the Sound coordinate system is on. (page 38)
— 9 —