Sound Setup
DTA (Digital Time Alignment) setting
Adjusting fine tuning of the speaker position compensation value specified at <Cabin selection> (Page 25).
1Enter DTA setting mode
Select “SOUND” > “Setup” > “DTA”.
For how to select Function Control item, refer to <Function Control> (page 6).
2Select the speaker you want to set
Setting speaker |
| Display |
Front speaker |
| “Front” |
Rear speaker |
| “Rear" |
Subwoofer |
| “SW" |
Turn the Control knob.
3Set the compensation value of the speaker position
Turn the Control knob and push the center when the desired value is displayed. Adjust between 0 and 440 cm.
Refer to “DTA” of <Menu Glossary> (Page 42) on how to set the compensation value.
Exit DTA setting mode.
X’Over setting
Fine adjusting the following setting values corresponding to the X’Over values set in the section <Speaker Setting> (Page 25);
Adjustment Item |
| Display |
| Range |
Front High Pass Filter, |
| “FC” |
| Through, 30, 40, 50, 60, 70, |
Rear High Pass Filter |
|
| 80, 90, 100, 120, 150, 180, | |
|
|
|
| 220, 250 (Hz) |
Front High Pass Slope, |
| “SLOPE” |
| |
Rear High Pass Slope, |
|
|
|
|
Subwoofer Slope |
|
|
|
|
Subwoofer Low Pass |
| “FC” | 30, 40, 50, 60, 70, 80, 90, | |
Filter |
|
| 100, 120, 150, 180, 220, 250, | |
|
|
|
| Through (Hz) |
Subwoofer Phase |
| “PHASE” |
| Reverse (180°)/ Normal (0°) |
1Enter X’Over setting mode
Select “SOUND” > “Setup” > “X’Over”.
For how to select Function Control item, refer to <Function Control> (page 6).
2Select the speaker you want to set
Setting speaker |
| Display |
Front speaker |
| “Front” |
Rear speaker |
| “Rear" |
Subwoofer |
| “Subwoofer" |
Turn the Control knob and push the center when the desired item is displayed.
3Select the item you want to set
Item |
| Setting overview |
“Front” | >“FC” | Front High Pass Filter |
| >“SLOPE” | Front High Pass Slope |
“Rear" | >“FC” | Rear High Pass Filter |
| >“SLOPE” | Rear High Pass Slope |
“Subwoofer" >“FC” | Subwoofer Low Pass Filter | |
| >“SLOPE” | Subwoofer Slope |
| >“PHASE” | Subwoofer Phase |
Push the Control knob towards up or down.
4Set the X’Over value Turn the Control knob.
5Repeat steps 2 to 4 to complete the X’Over setting.
6Exit X’Over setting mode Press the [FNC] button.
26