Kenwood KIV-BT900 General, Tuner source, Audio file source

Troubleshooting Guide

Some functions of this unit may be disabled by some settings made on this unit.

!			• Cannot set up the subwoofer.
			• No output from the subwoofer.
			• Cannot set up the subwoofer position of Manual
			position setting.
			▲ • The Dual zone function is enabled.
			 <Dual Zone System> (page 43)
			• In the speaker select option, None is selected for
			the subwoofer.
			 <Speaker Setting> (page 44)
	!		• Cannot set up the equalizer.
			• Cannot set up the Bass Boost.
			• Cannot set up the Highway sound.
			• Cannot set up the Supreme.
			• Cannot set up the Position control.
			▲ • The Dual zone function is enabled.
			 <Dual Zone System> (page 43)
			• The DSP function is disabled.
			 “DSP Set” of <Audio Control> (page 40)
			• In the speaker select option, None is selected for
			the rear speakers.
			 <Speaker Setting> (page 44)
	!		• Cannot select the output destination of the
			subsource in the Dual zone.
			• Cannot adjust the volume of the rear speakers.
			▲ The Dual zone function is disabled.
			 <Dual Zone System> (page 43)
!			• Cannot set up Display.
			▲ <Demonstration Mode Setting> (page 39) is not
			turned off.

 !  • Cannot switch to USB/iPod or Internal Memory source.

▲• The Dual zone function is set to USB/iPod or Internal Memory.

<Dual Zone System> (page 43)

▲• AV output function is set to ON.

“AV Out Set” of <Initial Settings> (page 38)

 !  The number of songs contained in “Songs” category of this unit is different from that contained in “Songs” category of iPod.

▲ Podcast files are not counted in this unit as this unit does not support the playback of podcast files.

What might seem to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems.

General

 ?  The Touch Sensor Tone does not sound.

The preout jack is being used.

The Touch Sensor Tone cannot be output from the preout jack.

 ?  The illumination flashes when the knob or button is operated.

This is the key illumination effect.

You set this effect in “ILLUMI Effect” of <Display Setting> (page 34).

 ?  The key illumination effect brought about in conjunction with the sound volume is small.

The key illumination effect may be insufficient depending on the sound volume and sound quality.

Tuner source

 ?  Radio reception is poor.

The car antenna is not extended.  Pull the antenna out all the way.

Audio file source

 ?  The sound skips when an Audio file is being played.

The recording condition is bad.

 Record the media again or use another media.

English 79