Accessories

Before Installation

1

5

........1

........4

2

6

........2

........4

3

7*

2 m (6.5 ft)....1

3m (9.5 ft)....1

4

 

5 m (16.4 ft)....1

* KIV-BT901 only

Installation Procedure

1.To prevent a short circuit, remove the key from the ignition and disconnect the - battery.

2.Make the proper input and output wire connections for each unit.

3.Connect the speaker wires of the wiring harness.

4.Connect the wiring harness wires in the following order: ground, battery, ignition.

5.Connect the wiring harness connector to the unit.

6.Install the unit in your car.

7.Reconnect the - battery.

8.While pressing the [Volume] knob and the [MENU] button, press the [SRC] button for at least 3 seconds.

14 Quick Start Guide

2WARNING

If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box.

¤

Mounting and wiring this product requires skills and experience. For safety’s sake, leave the mounting and wiring work to professionals.

Make sure to ground the unit to a negative 12V DC power supply.

Do not install the unit in a spot exposed to direct sunlight or excessive heat or humidity. Also avoid places with too much dust or the possibility of water splashing.

Do not use your own screws. Use only the screws provided. If you use the wrong screws, you could damage the unit.

If the power is not turned ON (“Protect” is displayed), the speaker wire may have a short-circuit or touched the chassis of the vehicle and the protection function may have been activated. Therefore, the speaker wire should be checked.

If your car’s ignition does not have an ACC position, connect the ignition wires to a power source that can be turned on and off with the ignition key. If you connect the ignition wire to a power source with a constant voltage supply, as with battery wires, the battery may die.

If the fuse blows, first make sure the wires aren’t touching to cause a short circuit, then replace the old fuse with one with the same rating.

Insulate unconnected wires with vinyl tape or other similar material. To prevent a short circuit, do not remove the caps on the ends of the unconnected wires or the terminals.