Installation/Removing the Unit
Bend the tabs of the mounting sleeve with a screwdriver or similar tool and attach it in place.
⁄
•Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (for example, the sound may skip).
Japanese cars
1.Refer to the section <Removing the hard rubber frame> and then remove the hard rubber frame.
2.Align the holes in the unit (two locations on each side) with the vehicle mounting bracket and secure the unit with the accessory screws.
T N
Removing the hard rubber frame
1.Engage the catch pins on the removal tool and remove the two locks on the upper level.
Lift up and pull the frame forward as shown in the figure.
Lock Catch
Removal tool (Accessory 2)
2.When the upper level is removed, remove the lower two locations.
⁄
•The frame can be removed from the bottom side in the same manner.
Removing the Unit
1.Refer to the section <Removing the hard rubber frame> and then remove the hard rubber frame.
2.Insert the two removal tools deeply into the slots on each side, as shown.
3.Lower the removal tool toward the bottom, and pull out the unit halfway while pressing towards the inside.
N T
5 6
T/N
T: Toyota cars
N: Nissan cars
Accessory 2
8 mm | 8mm | |
MAX. | ||
MAX. | ||
|
ø5mmø5mm
Accessory 5...for Nissan car
Accessory 6...for Toyota car
¤
•Be careful to avoid injury from the catch pins on the removal tool.
4.Pull the unit all the way out with your hands, being careful not to drop it.
18 Quick Start Guide