3 EN

Installation

7Notes on heat generation
•This unit incorporates a ventilation fan to process heat gen-
erated during operation. As the fan starts to rotate automati-
cally when the internal temperature of this unit rises, avoid
installing or setting which may prevent ventilation of the unit.
* Leave clearance of more than 10 cm (4 in.) to the left and
right, more than 50 cm (20 in.) above and more than 10 cm
(4 in.) in front and rear of the unit. Also, do not close the
surroundings of the unit tightly when it is mounted on a rack.
•The ventilation fan of this unit has been designed to intake
external air into the unit. If curtain or a piece of paper is attracted by the air intake, the internal temperature will rise and protection
circuitry will be activated. In this case, the sound will not be output.
Connection of banana plugs (Except for some countries, like
Singapore, etc.)
1 Secure. 2 Insert.
Connections of speaker cords
1 Strip coating. 2 Loosen. 3 Insert. 4 Secure.
• Sound will not be heard if the speaker terminal is not fully secured.

Connections

Make connection as shown below. When connecting the related system components, refer also to the instruction manuals of the
related components. Do not plug in the power lead until all connections are completed.
7Connections of speaker cords
For U.S.A.
CAUTION:
If the unit is used in the U.S.A., please read the
supplement to the operating instruction entitled
“Connection of speaker cords”.
Warning!
Particular attention must be given to making
good electrical contact at the amplifier-output
and speaker terminals.
Poor or loose connections can cause sparking
or burning at the terminals because of the very
high power that the amplifier can deliver.
CAUTIONS:
•Connect all cords firmly. If connections are loose, there could be loss of sound or noise produced.
•Never attempt to connect two or more speaker cords to a single speaker terminal.
•Never short-circuit the + and - speaker cords.
•If the left and right speakers are connected inversely or if the speaker cords are connected with reversed polarity, the sound
becomes unnatural with ambiguous acoustic image positioning. Be sure to connect the speakers and speaker cords correctly.

Unpacking

Unpack the unit carefully and make sure that all accessories
are put aside so they will not be lost.
Examine the unit for any possibility of shipping damage. If your
unit is damaged or fails to operate, notify your dealer immedi-
ately. If your unit was shipped to you directly, notify the ship-
ping company without delay. Only the consignee (the person
or company receiving the unit) can file a claim against the car-
rier for shipping damage.
We recommend that you retain the original carton and packing
materials for use should you transport or ship the unit in the
future.

Accessories

Audio cord (1) Stereo mini-plug cord (1) Speaker terminal cover (1) (Except for Europe)
More than
10 cm (4 in.)
More than
10 cm (4 in.)
More than
10 cm (4 in.)
More than
50 cm (20 in.)
More than
10 cm (4 in.)