troubleshooting
problem
●The whisk or
reaching the ingredients in the bottom of the bowl. solution ● Adjust the height using the spanner provided. Here’s how:
1Unplug the appliance.
2Raise the mixer head and insert the whisk or beater.
3Lower the mixer head. If the clearance needs to be adjusted, raise the mixer head and remove the tool.
4Using the spanner provided loosen the nut sufficiently to allow adjustment of the shaft . To lower the tool closer to the bottom of the
bowl, turn the beater shaft
5
6Fit the tool to the mixer and lower the mixer head. For best performance
the whisk or
7Repeat the above steps as necessary until the tool is set correctly. Once this is acheived tighten the nut securely.
flexible beater | Ideally the flexible beater should be almost touching the bottom of the |
| bowl but ensure that the flexible beater wing is not bent against the bowl |
| base as this will cause excessive wear. If necessary adjust as detailed |
| above. |
dough hook | This tool is set at the factory and should require no adjustment. |
problem
●The mixer stops during operation.
solution ● Your mixer is fitted with an overload protection device and will stop if overloaded to protect the machine. If this happens, switch off and unplug the mixer. Remove some of the ingredients to reduce the load, and allow the mixer to stand for a few minutes. Plug in and press the start button. If the mixer does not restart immediately allow to stand for additional time to allow the mixer to cool down.
5