Protect (Blink):
| The speaker wire has a |
| touches the chassis of the vehicle, and then |
| the protection function is activated. |
| ➪ Wire or insulate the speaker cable properly |
| and press the reset button. If the “Protect” |
| code does not disappear, consult your |
| nearest service center. |
No Device: | The USB device is selected as a source |
| although no USB device is connected. |
| ➪ Change the source to any source other |
| than USB. Connect an USB device, and |
| change the source to USB again. |
N/A Device: | • An unsupported USB device is connected. |
| • Connection to the iPod has failed. |
| ➪ Check that the connected iPod is an iPod |
| that is supported. See <About Audio file> |
| (page 21) for information on supported |
| iPods. |
No Music Data/No Music:
•The connected USB device contains no playable audio file.
•Media was played that does not have data recorded that the unit can play.
USB Error: | Some trouble may have occurred to the |
| connected USB device. |
| ➪ Remove the USB device, then cycle the |
| power switch to ON. If the same display is |
| repeated, use another USB device. |
REMO ERROR: Some trouble may have occurred to the connected Remoto control.
➪Remove the Remoto control and then reconnect it.
USB REMOVE (Blink):
The Remove mode has been selected for the USB device. You can remove the USB device safely.
iPod REMOVE (Blink):
The Remove mode has been selected for the iPod. You can remove the iPod safely.
FAV : No Memory:
The procedure is not registered to Favorite
Preset Memory
NO ACCESS: | The procedure preset with Favorite Control |
| cannot be available. The preset content may |
| not be recalled depending on the selected |
| source or mode. |
English 27