English
What might seem to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems.
| PROBLEM | POSSIBLE CAUSE | SOLUTION | ||
|
|
| ||
The power does not turn on. | The fuse has blown. | After checking for short circuits in the wires, replace the | ||
|
|
| fuse with one with the same rating. | |
|
|
| ||
No sound can be heard, or the | Attenuator is turned on. | Turn off Attenuator. | ||
volume is low. |
|
| ||
The fader or balance settings are set all the way to one | Reset the fader or balance settings. | |||
|
| |||
|
| side. |
| |
|
|
|
| |
|
| The input/output wires or wiring harness are connected | Reconnect the input/output wires or the wiring harness | |
|
| incorrectly. | correctly. See the section on "Connecting Wires to | |
|
|
| Terminals". | |
|
|
|
| |
|
| The cassette tape is bad. | Try playing another cassette tape. If works fine, the first | |
|
|
| tape was bad. | |
|
|
| ||
The tape does not go in. / | The car ignition was turned off during tape eject; or the | Press the Eject button. | ||
No sound can be heard even | tape was pulled out during loading, switching the mode to |
| ||
though the tape display is | tape mode even though no tape is in. |
| ||
made. |
|
| ||
|
|
| ||
Nothing happens when the | The computer chip in the unit is not functioning normally. | Press the reset button on the unit (see p. 4). | ||
buttons are pressed. |
|
| ||
|
|
| ||
The sound quality is poor or | The tape head is dirty. | Clean the tape head, referring to the section on "Cleaning | ||
distorted. |
| the tape head" (see p. 4). | ||
|
|
|
| |
|
| One of the speaker wires is being pinched by a screw in | Check the speaker wiring. | |
|
| the car. |
| |
|
|
|
| |
|
| The speakers are not wired correctly. | Reconnect the speaker wires so that each output | |
|
|
| terminal is connected to a different speaker. | |
|
|
|
| |
Radio reception is poor. | The car antenna is not extended. | Pull the antenna out all the way. | ||
|
|
|
| |
|
| The antenna control wire is not connected. | Connect the wire correctly, referring to the section on | |
|
|
| "Connecting Wires to Terminals". | |
|
|
| ||
The memory is erased when | The battery wire has not been connected to the proper | Connect the wire correctly, referring to the section on | ||
the ignition is turned off. | terminal. | "Connecting Wires to Terminals". | ||
|
|
|
| |
|
| The ignition and battery wire are incorrectly connected. | Connect the wire correctly, referring to the section on | |
|
|
| "Connecting Wires to Terminals". | |
|
|
|
| |
— 22 —