![](/images/new-backgrounds/1002383/238353x1.webp)
"CODE" appears in the display, you can start inputting the code.
6Press the Preset button and input the security code again.
7Hold down the DISP button again for three seconds or more. "APPROVED" will appear in the display, with the code security function turning on. From this point on, if the unit is disconnected from the battery, the security code must be entered the first time that the unit's power is turned on. "ENTER" and "CODE" will appear in the display, asking you to input the code.
NOTE
If you input an incorrect security code, the code setting mode will be cancelled automatically. Follow the steps from 3 to 7 above again.
If you press the RESET button or remove the battery:
The first time you turn the unit on again, "CODE" will appear in the display, asking you to input the security code.
Repeat steps 6 and 7 above, and input the security code. You can start operating the unit again when "APPROVED" appears in the display.
NOTE
If you enter the wrong code, “Waiting” is displayed and you cannot make further input of the code for a fixed interval (see table below), which grows longer each time you enter the wrong code.
When "CODE" is displayed, you can make input again.
Number of wrong | Interval until next input |
inputs | is allowed |
1 | - |
2 | 5 minutes |
|
|
3 | 1 hour |
4 | 24 hours |
|
|
The number of wrong inputs is displayed.
Touch Sensor Tone
This function produces a beep sound that accompanies button operation. It can be switched on or off.
Display and setting:
"Beep ON" : Beep setting is on. (Default setting)
"Beep OFF" : Beep setting is off.
NOTE
The beep sound is not output from the preout jacks.
Manual Time Adjustment
Adjust the time manually.
NOTE
This adjustment is available only when the automatic time adjustment is set to off. (page 28)
Display and setting:
1Select the display "Clock Adjust" during the selecting function in the menu system.
2Hold down either the 4 or ¢ button for one second or more to enter the Manual time adjustment mode.
The time display will blink.
3• Adjusting the hours
Press the FM button to advance the hours, or press the AM button to make the hours go back.
•Adjusting the minutes
Press the ¢ button to advance the minutes, or press the 4 button to make the minutes go back.
4Press the MENU button to end the Manual Time Adjustment mode.
Exiting the Manual Time Adjustment mode would start the clock counting.
— 27 —