18 EN
Listening to a source component
1
Use the INPUT SELECTOR knob or keys to select the source
you want to listen to.
The input sources change as shown below:
1“AUX”
2“TUNER”
3“CD/DVD”
4“TAPE” or “MD”
5“VIDEO1”
6“VIDEO2”
7“DVD” or “DVD/6CH” (for VR-715/KRF-V5070D only)
2
Start playback from the selected source.
3
Use the VOLUME CONTROL knob or VOLUME keys to adjust
the volume.
Normal playback
Some preparatory steps are needed before starting playback.
Turning on the receiver
1Turn on the power to the related components.
2Turn on the power to this receiver by pressing POWER ON/
STANDBY (for VR-705/715) or POWER ON/OFF and ON/
STANDBY (for KRF-V5070D/V4070D/V5570D) key.
Selecting the input mode
If you have selected a component connected to the CD/DVD, VIDEO2,
DVD or DVD/6CH (VR-715/KRF-V5070D only) jacks, make sure that
the input mode setting is correct for the type of audio signal to be used.
8
Selecting MD/TAPE
Select the source name corresponding to the component connected to
the MD/TAPE jacks. The initial factory setting is “TAPE”. To change the
source to “MD”, follow the steps below:
1Use the INPUT SELECTOR knob to select “TAPE”.
2Hold down the AUTO key for more than 2 seconds.
• The source indication changes to “MD”.
• To return to the original indication, repeat procedure 2.
Setting the speaker status
Press the SPEAKERS ON/OFF key to switch the speaker on or off.
Preparing for playback
The speaker indicator lights up.
AUTO INPUT SELECTOR
(KRF-V5070D/
V4070D/
V5570D)
POWER
ON/OFF
SPEAKERS
ON/OFF
ON/STANDBY
(KRF-V5070D/ V4070D
/
V5570D)
(VR-705/715)
POWER
ON/STANDBY
INPUT SELECTOR
VOLUME CONTROL
Input
Selector
VOLUME
*5337/16-20/EN 27/12/02, 1:05 PM18