Bare Floor Cleaning (Continued)
4. Fill the Water Tank with Hot Tap Water and Set Aside.
5. Attach the Bare Floor Tool onto the Floor Nozzle with the long tab to the right side of the Floor Nozzle. First attach left side (short tab) catching tab over nozzle edge. Gently bend long Tab (right side) outward to easily snap over edge of clear nozzle on left.
6.Set the Ready Tools Dial to Floor Cleaning.
7.Set the SmartMix Dial to Normal Clean.
8. | Plug into an outlet and turn the Power Switch and |
| Bottom Front Edge |
9. | Heater ON ( I ). |
| of Floor Nozzle |
Slowly move the machine forward and back over | Bare Floor |
| |
| bare floor surface one time while pressing trigger. | Cleaning Tool | Snap Together |
10. | Caution: Do not overwet. |
|
|
Repeat the motion without pressing the trigger. |
|
| |
| This allows the Bare Floor tool to squeegee and |
|
|
11. | suction up the dirty water. |
|
|
Allow approximately 30 minutes for floors to dry. |
|
| |
12. | Remove Bare Floor tool and rinse and dry |
|
|
13. | before storing. |
|
|
If any formula remains in the Formula Tank, pour | WARNING: | ||
| it back into the Hard Floor Solutions bottle for use | ||
| the next time. | ||
14. | Rinse out the Formula Tank. | To reduce the risk of fire, | |
|
| electric shock or injury | |
Troubleshooting / User Maintenance | unplug from outlet before | ||
servicing. |
| ||
| SmartTemp Ready Light does not illuminate. |
|
|
| Possible Causes | Remedies |
|
| 1. The SmartTemp Switch is not turned ON ( I ). | 1. Turn ON ( I ) the SmartTemp | |
|
| Switch. |
|
2.The machine Power Switch is not to turned ON ( I ).
2.Both switches must be ON ( I ) to activate the SmartTemp Ready Light.
Reduced spray or no spray.
Possible Cause
1.Bladder may be empty.
2.SmartMix Tank may be empty.
3.The filter may be clogged.
4.Tanks may not be seated properly.
5.Pump may have lost prime.
Remedies
1.Refill Bladder with hot tap water.
2.Fill with BISSELL Fiber Cleansing Formula for cleaning. Fill with water if rinsing or using the Scotchgard applicator.
3.Clean out Flow Indicator Filter, page 12.
4.Turn power OFF (O); remove & reseat tanks.
5.Turn power OFF (O); after 1 minute turn ON and press Trigger.
16 w w w . b i s s e l l . c o m
8 0 0 . 2 3 7 . 7 6 9 1
3/1/06 3:14:03 PM |