After Cleaning (Continued)
Machine Care
Flow Indicator
For best results, a few simple steps can assure your machine is well maintained after your cleaning is complete.
1. | Turn Power and Heater switches OFF ( 0 ). Unplug |
| |
2. | the machine and wrap the power cord. |
| |
After emptying the Water Tank, rinse it out at a |
| ||
| faucet with running hot tap water, taking care to |
| |
| clean underneath the Heavy Duty Bladder, and all |
| |
3. | around it. Clean out lint trap. |
| |
Replace the Tank in tank on the machine. | 4 | ||
4. | Clean out the flow indicator filter each time it is used | ||
|
to ensure best cleaning performance. Unscrew the Flow indicator cap, lift out the red rotor and white filter. Rinse all three parts with water. Replace the filter and rotor. Replace the Flow indicator cap. Turn until snug, do not
5.Any loose hair or debris can be pulled from the brush roll if desired and thrown away.
6.Wipe the machine’s exterior with a soft cloth.
7.After carpet is dry, vacuum again to remove hair and fuzz.
Some ProHeat models are equipped with a Scotchgard Protector post treatment applicator and cartridge. Using this, along with one of the BISSELL cleaning formulas containing Scotchgard, helps
to retain the carpet cleanliness achieved with the ProHeat machine. For best results, the post cleaning treatment should be applied while the carpet is still damp. It is recommended that the Scotchgard protector be applied every 12 months to all clean carpeted areas, and after every deep cleaning for high traffic areas such as entry ways and stairs.
1.Immediately after cleaning and rinsing your carpets, empty the Water Tank and refill the Heavy Duty Bladder with clean, hot tap water.
2.Set the Ready Tools dial to the Tools/Pretreat setting. This will allow spray from the hose.
3.Purge the hose to eliminate cleaning solution from the tube by spraying clean water through the hose without attachments into a sink for
4.Attach Scotchgard
5.Turn the SmartMix Dial to the Water Rinse/Carpet
Protector setting.
12 w w w . b i s s e l l . c o mTip:
If clogged, soak applicator tool in hot tap water before using.
3
4
8 0 0 . 2 3 7 . 7 6 9 1
3/1/06 3:13:52 PM |